Control Column Ribbon....
 

The ribbon wire that goes thru the control column. I had problems

several years back with one of the switches on the control wheel.

I am having trouble with the map light now. If memory serves me

correct, I think my mech used another wire that ran thru the

ribbon to remedy the problem back then. I have noticed on other

337's a different arrangment, a heavy coiled wire coming out of

the lower panel and I believe going to the control wheel. Is there

a fix for other than the ribbon wire or is it best to try and replace

the ribbon wire? thanks, guy, the old 72 driver....

mine had problems a few years back.
was replaced with multi conductor cable
with each conductor shielded. never have had a problem since. took less than 3hrs
to fix.

Guy
Sent you an email regarding this.
Use a multicore coiled cable, and run under panel to the grey round connector which should be by the control column.

Regards
Pete

Control column ribbon....
 

Thanks for all the inputs.... guy, the old 72 driver....