Skymaster Forum  

Go Back   Skymaster Forum > Search Forums
Register FAQ Members List Calendar Today's Posts

Showing results 1 to 25 of 110
Search took 0.01 seconds.
Search: Posts Made By: kbecker
Forum: Messages 09-02-24, 01:31 PM
Replies: 12
Views: 7,588
Posted By kbecker
Mfr part 627458

Mfr part 627458
Forum: Messages 09-01-24, 12:51 AM
Replies: 12
Views: 7,588
Posted By kbecker
I’ll look it up tomorrow when I have access to my...

I’ll look it up tomorrow when I have access to my laptop computer
Forum: Messages 08-30-24, 02:28 PM
Replies: 12
Views: 7,588
Posted By kbecker
I just went through this on my annual inspection...

I just went through this on my annual inspection yesterday. I was running 30 psi in cruise and wanted it around 40.

I purchased the replacement springs though Spruce, looking up the numbers in the...
Forum: Messages 05-29-24, 10:47 PM
Replies: 2
Views: 4,917
Posted By kbecker
My 337G has the dataplate to the right of the...

My 337G has the dataplate to the right of the co-pilots outboard seat track under the carpet.
Forum: Messages 01-31-24, 10:51 PM
Replies: 10
Views: 43,587
Posted By kbecker
Did they take the spinner bulkhead off before...

Did they take the spinner bulkhead off before flying it without the spinner?

Kevin
Forum: Messages 01-23-24, 11:53 PM
Replies: 6
Views: 24,993
Posted By kbecker
Here is a video that explains it. I don't know...

Here is a video that explains it. I don't know if this is relevant to the 337.

https://www.youtube.com/watch?v=zJFFPa40Tpk
Forum: Messages 01-23-24, 11:50 PM
Replies: 6
Views: 24,993
Posted By kbecker
I know some Cessna's have an adjustment at the...

I know some Cessna's have an adjustment at the spar attachment with the wing that allows you to increase or decrease the pitch of the wing (I'm probably not describing that correctly), but if the...
Forum: Messages 01-21-24, 01:12 AM
Replies: 6
Views: 24,993
Posted By kbecker
Did you test for tail boom twist? As I recall...

Did you test for tail boom twist? As I recall you can measure in an "X" pattern as one of the methods to check for this.

Kevin
Forum: Messages 01-18-24, 05:37 PM
Replies: 5
Views: 38,377
Posted By kbecker
Here is the one I have. Let me know if this works...

Here is the one I have. Let me know if this works for you.

Kevin
Forum: Messages 01-15-24, 05:15 PM
Replies: 5
Views: 38,377
Posted By kbecker
I may have one of these on the shelf at the...

I may have one of these on the shelf at the hangar. Will check on Thursday if you can wait until then.

Kevin
Forum: Messages 11-29-23, 11:27 PM
Replies: 10
Views: 50,398
Posted By kbecker
Thanks! Kevin

Thanks!

Kevin
Forum: Messages 11-29-23, 11:05 AM
Replies: 10
Views: 50,398
Posted By kbecker
Thank you for all of the positive comments!

Thank you for all of the positive comments!
Forum: Messages 11-28-23, 09:53 PM
Replies: 10
Views: 50,398
Posted By kbecker
The whole time I was thinking “Don’t F**k up, and...

The whole time I was thinking “Don’t F**k up, and don’t say something stupid”
Forum: Messages 11-28-23, 06:55 PM
Replies: 10
Views: 50,398
Posted By kbecker
He shot that video with a 360 degree GoPro and an...

He shot that video with a 360 degree GoPro and an iPhone. No other cameras. We flew for about 45 min, and he edited it into a shorter video.

I’m glad I greased that landing…..I knew he was filming...
Forum: Messages 11-28-23, 12:04 AM
Replies: 10
Views: 50,398
Posted By kbecker
New YouTube Video promoting the 337

https://www.youtube.com/watch?v=PAaLgx1dH7Y&t=76s

Trying my best to promote the 337. I was pleasantly surprised at all of the positive comments left by viewers about the 337.

Kevin
Forum: Messages 11-05-23, 01:08 AM
Replies: 1
Views: 30,546
Posted By kbecker
Advice Needed--Fuel Flow Sensor Placement

77 337G, normally aspirated.

I am upgrading my engine monitor and this time including fuel flow sensors. My mechanic and I looked at the engine compartments today to determine how to re-route the...
Forum: Messages 10-29-23, 04:28 PM
Replies: 15
Views: 83,415
Posted By kbecker
I fly a normally aspirated 337G. My caution is...

I fly a normally aspirated 337G. My caution is not to try to retract the flaps until the gear is fully retracted and the power pack is off. I tried this before and the electrical load from the...
Forum: Messages 09-26-23, 10:42 PM
Replies: 5
Views: 34,257
Posted By kbecker
I had my lower strut fairings off a few months...

I had my lower strut fairings off a few months ago at annual and there were no gaskets to seal off this area. I also don't see any in the parts manual.

Kevin
Forum: Messages 04-01-23, 05:36 PM
Replies: 12
Views: 50,790
Posted By kbecker
I have an older Insight model, the 1200, and have...

I have an older Insight model, the 1200, and have liked it. My complaints are related to its age--the technology to download the data is via some HP Palmtop.

Insight has fixed this with the newer...
Forum: Messages 03-04-23, 07:49 PM
Replies: 6
Views: 26,977
Posted By kbecker
I have a seat from a 73P model available. I...

I have a seat from a 73P model available. I don't know if its the left or the right seat. If interested I can send you pictures.

Kevin
Forum: Messages 02-09-23, 11:48 AM
Replies: 47
Views: 265,595
Posted By kbecker
Just called my local avionics shop--they hadn't...

Just called my local avionics shop--they hadn't heard of this but I passed on the contact info and he is going to call. I will put dowm my deposit after my avionics guy gets confirmation.

Kevin
Forum: Messages 01-16-23, 02:19 PM
Replies: 5
Views: 98,183
Posted By kbecker
Not sure that the rear engine oil breather would...

Not sure that the rear engine oil breather would be able to get oil on the aft part of the rear propeller.
Forum: Messages 01-11-23, 08:48 PM
Replies: 4
Views: 29,684
Posted By kbecker
Would someone be kind enough to post MEL 28-02 to...

Would someone be kind enough to post MEL 28-02 to the board?

Kevin
Forum: Messages 09-30-22, 06:08 PM
Replies: 10
Views: 18,972
Posted By kbecker
I learned this cowl flap lesson the hard way by...

I learned this cowl flap lesson the hard way by burning out my front cowl flap motor years ago because one of the limit switches was mis-adjusted.
Forum: Messages 08-26-22, 08:01 PM
Replies: 34
Views: 83,281
Posted By kbecker
I have a brand new version 2--the flat one. That...

I have a brand new version 2--the flat one. That is also the one I have installed in my plane. I don't have the one with the "wings" on the end.

The ends of the flat one are different--both have a...
Showing results 1 to 25 of 110

 
Forum Jump

All times are GMT -4. The time now is 07:43 PM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.