Forum: Messages
09-03-24, 12:34 PM
|
Replies: 12
Views: 7,588
|
Forum: Messages
08-30-24, 04:10 PM
|
Replies: 12
Views: 7,588
|
Forum: Messages
08-30-24, 01:36 PM
|
Replies: 12
Views: 7,588
Ok- I know the oil pressure issue is not the...
Ok- I know the oil pressure issue is not the gauge. Swapping the gauge confirmed same low readings.
I also was able to get the cold oil pressure adjusted to the top of green, however, it took almost...
|
Forum: Messages
08-26-24, 01:54 PM
|
Replies: 12
Views: 7,588
Thanks All
Joes - How do you do that? I have...
Thanks All
Joes - How do you do that? I have 337D, I thought it's a "printed" circuit board with a connection plug on the left lower side of the board.
I haven't got back there to see if it the...
|
Forum: Messages
08-15-24, 01:08 PM
|
Replies: 12
Views: 7,588
Confusing Oil Pressure / Temp issue
Anyone chased this down before?
IO306C non Turbo
Oil pressure is fine cold. Once Temp rises, oil pressure falls off, just out of lower green. When in this mode, oil temp never gets to 180 in...
|
Forum: Parts For Sale
05-24-24, 05:43 PM
|
Replies: 3
Views: 6,061
|
Forum: Parts For Sale
05-24-24, 02:24 PM
|
Replies: 3
Views: 6,061
|
Forum: Messages
11-29-23, 01:53 PM
|
Replies: 10
Views: 50,398
|
Forum: Messages
08-02-23, 04:54 PM
|
Replies: 14
Views: 51,166
|
Forum: Messages
07-13-23, 04:59 PM
|
Replies: 1
Views: 22,992
|
Forum: Messages
07-11-23, 01:38 PM
|
Replies: 14
Views: 51,166
|
Forum: Messages
07-10-23, 01:19 PM
|
Replies: 14
Views: 51,166
|
Forum: Messages
07-09-23, 11:08 PM
|
Replies: 14
Views: 51,166
|
Forum: Messages
07-05-23, 02:08 PM
|
Replies: 14
Views: 51,166
|
Forum: Messages
07-03-23, 12:07 PM
|
Replies: 6
Views: 16,598
MSHAC -
It was the motor. Installed a "new to...
MSHAC -
It was the motor. Installed a "new to me" one, flew and everything worked great.
It now takes 6 seconds to extend and retract vs 10, sounds much better and no circuit pop!
It was a 30min...
|
Forum: Messages
06-25-23, 09:23 PM
|
Replies: 6
Views: 153,980
|
Forum: Messages
06-23-23, 10:52 AM
|
Replies: 14
Views: 51,166
Fuel Flow Setup in NoCal
Hello Everyone -
Does anyone know of a mechanic in the Northern California area who is familiar with setting up the fuel flow on these Continental IO-360s and the Skymaster?
Thanks,
Bryan
|
Forum: Messages
06-13-23, 07:32 PM
|
Replies: 6
Views: 16,598
Thanks MSHAC
Well today we did what you...
Thanks MSHAC
Well today we did what you suggested and was able to replicate the pop by putting some resistance on the flaps. Indeed popped anything past 1/3.
Breaker has been replaced. I'm now...
|
Forum: Messages
06-12-23, 03:15 PM
|
Replies: 6
Views: 16,598
Flap Circuit Pops
Hi Everyone -
In flight, my flap 10 amp circuit pops on anything past 1/3. Works fine on the ground. So I do most of my landings at 1/3.
Any ideas? Circuit was replaced. Motor tired? Anyone...
|
Forum: Messages
05-31-23, 12:56 PM
|
Replies: 6
Views: 153,980
|
Forum: Messages
05-30-23, 10:32 AM
|
Replies: 2
Views: 16,256
|
Forum: Messages
05-29-23, 06:21 PM
|
Replies: 2
Views: 16,256
Rear Cowl Flap light micro switch location
Hi guys
I’m a little stumped. I have a 1969 337D and the light for the rear cowl flap does not come on. Bulb is good, swapped with front.
Switch opens and closes cowl flap and motor stops at the...
|
Forum: Parts Sources
02-28-22, 06:02 PM
|
Replies: 1
Views: 23,150
Bulkhead
These guys are great! I worked with Kim. Did both of my bulkheads!
|
Forum: Messages
01-27-22, 04:30 PM
|
Replies: 8
Views: 27,980
Centerline Thrust
Hi Everyone -
Here is my situation:
I have a 1969 337D that is being refurbished. Will be ready soon.
I need 15hrs dual for insurance and I need to get a Multi engine add on. I also need to break...
|
Forum: Messages
07-08-20, 07:39 PM
|
Replies: 7
Views: 14,510
|