Forum: Messages
05-30-23, 06:14 PM
|
|
Replies: 4
Views: 20,394
|
|
Forum: Messages
06-16-22, 03:33 PM
|
|
Replies: 3
Views: 19,733
Panel angle.
It turns out the panel angle on my Skymaster is zero, no tilt at all. I chose the RC Allen MINI6 because I already have the Uavionix and have not been pleased. It processes badly so you must correct...
|
|
Forum: Messages
06-15-22, 01:43 PM
|
|
Replies: 3
Views: 19,733
Panel Angle - How to calculate
I have a 1971 Skymaster 337F and am going to install a new RC Allen MINI6 instrument in the panel. The manufacture states that you must specify your panel angle when ordering. Does anyone know the...
|
|
Forum: Aircraft For Sale
04-30-17, 04:16 PM
|
|
Replies: 5
Views: 23,751
|
|
Forum: Messages
07-17-15, 02:57 PM
|
|
Replies: 3
Views: 18,165
Cabin is very hot!
Since I have owned my 337F it has been very hot inside the cabin after the front engine warms up. In cruise it feels like the heater is on high all of the time, even though all of the environmental...
|
|
Forum: Messages
04-28-14, 08:13 PM
|
|
Replies: 7
Views: 17,870
Problem Solved!
Thanks to all that had suggestions. We replaced the micro switch located under the panel right above the pilot's left knee. This switch controls the gear doors opening and closing. After replacing...
|
|
Forum: Messages
04-20-14, 11:43 AM
|
|
Replies: 7
Views: 17,870
Thanks for the help everyone.
I will check everything you guys suggested. We replaced all of the hydraulic hoses and then hooked up a mule and did many cycles to get all of the air out. We are replacing the micro switch now that...
|
|
Forum: Messages
04-18-14, 07:34 AM
|
|
Replies: 7
Views: 17,870
Gear Doors will not close
My 1971 337F landing gear work with no problem, however we are having trouble getting the gear doors to close. Flew it yesterday and everything worked fine on takeoff and initial gear retraction. The...
|
|
Forum: Messages
02-07-14, 05:23 PM
|
|
Replies: 1
Views: 12,895
|
|
Forum: Messages
01-02-14, 07:19 PM
|
|
Replies: 1
Views: 12,718
IO 360 C vs IO 360 G?
Can anyone tell me if Continental IO 360 G engines from a pressurized 337 would work in place of the IO 360 Cs that are in my 1971 337F?
Thanks for any help.
Yours for Christ,
Cliff
|
