Forum: Messages
05-13-19, 03:54 PM
|
Replies: 33
Views: 29,026
Tie Bar
Dave,
The tie bar is good for 428 Amps...ha ha. Yes, I used a wide piece, however that does not add anymore height than a skinny one - but you are right, that is what makes it tight. I would love to...
|
Forum: Messages
05-13-19, 03:39 PM
|
Replies: 33
Views: 29,026
Tall breakers
Dave,
Yes, it is a tight clearance. Without the sidewall in place, there is clearance, but it is close. I just double checked my part numbers, and it looks like I did order the tall ones...dammit. ...
|
Forum: Messages
05-13-19, 09:47 AM
|
Replies: 33
Views: 29,026
New CB Panel
Dr. Dave,
My apologies for the delayed reply, but thank you so much for the info and direction. I ordered the CB's and copper (from Quick Ship Metals) you referred to, and assembled my CB panel over...
|
Forum: Messages
04-02-19, 09:30 AM
|
Replies: 33
Views: 29,026
Dr.Dave,
Thanks for the tip on the Master...
Dr.Dave,
Thanks for the tip on the Master Avionics Breaker and Switch...Had not thought about that. With building a new CB panel, I like the ability to isolate certain things.
Yes, the studs on the...
|
Forum: Messages
04-01-19, 11:14 AM
|
Replies: 33
Views: 29,026
CB Panel rework
Hi Dr. Dave,
Well, I have also taken your advice from this thread, and I have started to run the new wires from the starter (GND) to starter, and new feed wires. As I am going through a major refit...
|
Forum: Messages
02-11-19, 11:05 AM
|
Replies: 33
Views: 29,026
Awesome info
Dr. Dave,
That info is immensely helpful and now I get it!!! Thank you for the taking the time on this electrical info - it is great to have this type of data to be proactive in eliminating...
|
Forum: Messages
02-06-19, 09:07 AM
|
Replies: 33
Views: 29,026
Thanks for expertise
Dave,
Just want to thank you for your expertise as well - I am reading your posts with great interest. You have a great way of explaining things.
One question I have is when you said "I like...
|