Thread: guide rollers on control column P version
View Single Post
  #1  
Unread 05-11-02, 04:01 PM
Bob Cook Bob Cook is offline
N69S
  
Join Date: Apr 2002
Location: CYYZ,MYAT
Posts: 561
Bob Cook is an unknown quantity at this point
help / rollers on control column P version
Skyking, GMAS

There was a thread earlier on the UNO board covering the replacement of the rubber rollers at the instrument panel (3) / guides for the control column.


did you mention about machining nylon rollers to fit over the bearings?

Last week I found the rubber sleeve on the floor and on the co-pilots side there are two out of three missing. Guess the cost from Cessna or Yingling is rather high.

Can you please resend the solution. Did you say you had some left over for sale ?

Tnx

Bob
Last edited by Bob Cook : 05-12-02 at 08:42 AM.
Reply With Quote