|
|
|||||||
| Register | FAQ | Members List | Calendar | Today's Posts | Search |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#1
|
|||
|
|||
Synchroscope
The prop synchroscope of our T337C started getting intermittant, and then became inop with the needle permanently reposing against the left stop. It is connected to two terminals on the back of the tac, and continuity tested good across these leads (155 ohms). Any thoughts on where the problem may lie short of pulling the tac and sending it out for repair?
__________________
Paul T337C 
|
Threaded Mode