Insight Flow sensors onto an IO-360-GB

[kilr4d]

Originally Posted by JAG

Hi Pat,

How did you make out on installing the flow sensor? I am getting ready to install the G4, and have the same question you do.
Thanks,
Jeff

Jeff, I have the G4 Twin (love it) and I'm piggybacking from the Shadin fuel flow transducers. I'll grab you a pic of the location tomorrow.

Regards,

John

[JAG]

Thanks John!

Any pictures of the install are appreciated. I am planning to 'T' into the oil pressure indication from in the panel (at the Cessna gauges), but did you do something different? Any advice on any of it is appreciated.

Thanks,
Jeff

[kilr4d]

Originally Posted by JAG

Thanks John!

Any pictures of the install are appreciated. I am planning to 'T' into the oil pressure indication from in the panel (at the Cessna gauges), but did you do something different? Any advice on any of it is appreciated.

Thanks,
Jeff

Here's the fuel flow transducers; the square aluminum boxes of course. They're plumbed into the main fuel line:

Front: https://imgur.com/lBRUW8q
Rear: https://imgur.com/y6EQVni

My oil pressure are taken directly front the crankcase; front of the engine not far from the propeller hub.

[pilotpat]

Thanks! Those locations should work for the Insight as well, and allow reuse of the existing hose for one of the legs. Is the white wire connecting to a temperature probe?

[JAG]

Appreciate those pictures John - I see exactly now where I will mount my sensors.
Jeff