|
|
|||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
Control Quadrant Clevis Pin Part Number?
J.
The bolt may seem to be incorrect but it's not. Fig 89/Item 8 Rear prop, Quad end. ATTACHING PARTS: AN 3-11A Bolt, NAS 679A3 Nut, NAS 43HT3-11 Spacer. Hope this helps. Regards. BILLS '65 C337 
|
|
#2
02-08-21, 11:14 AM
|
||||
|
||||
|
Bills,
In my fig 89/8 it shows the connection on the engine and not the control quadrant. Is yours different? https://ibb.co/xXzqh6k https://ibb.co/JH7tSGH
__________________
337B Philadelphia PA
|
|
#3
02-08-21, 12:49 PM
|
||||
|
||||
Control Quadrant Clevis Pin Part Number?
J. Sorry your skymaster must be newer than mine. But the same info for the rear prop should be the same, just different Fig/Item number.
BILLS
|
|
#4
02-08-21, 03:55 PM
|
|||
|
|||
|
337a
JHogan,
Your quadrant hardware is correct - bolts with spacers and nuts on the prop controls. My 66 has the same set up. Figure 89, item 7, has the listing for the hardware for the prop control, says "QUADRANT END OF CONTROL". Jeff Last edited by JAG : 02-08-21 at 04:03 PM.
|
|
#5
02-08-21, 09:55 PM
|
||||
|
||||
|
Thanks guys.
It Just didnt look right to me. Looks to me like some type of factory work around to avoid the rudder trim chain. Makes sense now 👍
__________________
337B Philadelphia PA
|
|
#6
02-09-21, 01:19 PM
|
||||
|
||||
|
I received an email from textron today with photos from their magic cessna books
 if anyone wants to see attached photoshttps://ibb.co/J2xKLkz https://ibb.co/7KFzNXb https://ibb.co/JFd3d3Z
__________________
337B Philadelphia PA
|
|
#7
02-09-21, 06:16 PM
|
||||
|
||||
|
Control Quadrant Clevis Pin Part Number?
J.
Thanks for the photos. Nice information for Skymaster Owners/mechanics. Regards, BILLS
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
