![]() |
|
Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Mine was stuck because the interconnect cable btw trim and flaps was stuck
To much anti corrosion treatment In your right rear part of tailboom and under right wing just outside boom you find the interconnect cable ends |
#2
|
||||
|
||||
Thanks everyone!
I will take a look at your suggestions, hopefully its nothing major. |
#3
|
||||
|
||||
Went out to my plane this weekend, getting ready to open the inspection panel where the servo is located ...I decided to once more Joggle the trim. I softly joggled it up/down for about 3-5 seconds, the trim wheel disengaged! Trim is working as it should now with the electric trim off. Must of been the heat that loosened it, LOL
I will still have the clutch looked at, at its next annual (3 months from now). Thanks everyone. Last edited by ljmolina : 06-20-22 at 12:01 PM. |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|