![]() |
|
Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Mich3773 thank you for the reply. I have the placard in your photo. I'm looking for the location of both the front and rear engine cowl flap placards that are in the attached photo at the beginning of this thread. Thank you again for your effort.
Rick
__________________
N337K-FT337GP KLOU |
#2
|
|||
|
|||
Check you flight manual. It has the location of the required placards and markings, it may show those
|
#3
|
|||
|
|||
Hi Kim, my Flight Manual doesn't mention or show these placards, I expect because they are not required, as those in the TCDS are.
Do any of your Skymasters have either, or both, of these placards? Rick
__________________
N337K-FT337GP KLOU |
#4
|
|||
|
|||
I think it was on the oil cooler baffle below the dip stick so you could see it if you opened the oil door.
|
#5
|
|||
|
|||
Thank you Kim, I’ll check out those locations as candidates…
Rick
__________________
N337K-FT337GP KLOU |
#6
|
|||
|
|||
Here is picture through my rear oil door
Hope it downloads ok See attached photo link Look like front one long gone Last edited by wslade2 : 11-02-22 at 09:44 PM. |
#7
|
|||
|
|||
Thank you wslade2! That's exactly what I needed for the rear cowl flaps.
Now to fill in the blank for the front cowl flaps... Perhaps by the oil cooler, like Kim mentioned. Rick
__________________
N337K-FT337GP KLOU Last edited by Rick Erwin : 11-02-22 at 11:53 PM. |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|