![]() |
|
Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
There is a rubber seal that seals the storm weather door. Might be that or maybe it’s not even there. It could be the frame also as it should be sealed to the window on the exterior side.
__________________
Herb R Harney 1968 337C Flying the same Skymaster for 47 years |
#2
|
||||
|
||||
CB panel wetness
Yes, of all placed to get wet...
Water getting past the windshield or even condensation inside can also run down the inner left edge and drool down there. Every few years I go through the ritual of resealing the edge along the plexiglas. 1. Autozone painters tape right along the edge of the airframe 2. Another line of painters tape about 1/8th down the plexi 3. Smear some decent flexible outdoor sealant between the two lines of tape. 4. Wipe excess 5, Remove tape 6. Let dry 7. Go flying 8. Stay dry
__________________
David Wartofsky Potomac Airfield 10300 Glen Way Fort Washington, MD 20744 |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|