![]() |
|
Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
My brake line swivel has seen better days. Someone previously beat the crap out of it and it is no longer serviceable or repairable. I found a replacement part which is a Phoenix C6-4-6. Cost about $10 plus shipping. Using FAR 43.13 to install. Far better replacement part than the original. Early serial number Skymasters had no brake swivels. I don't know the history on the swivel but I assume it was an improvement done by Service Bulletin in the early days. Then incorporated into later production airplane.
|
#2
|
||||
|
||||
Awesome news brother!
|
#3
|
|||
|
|||
Does that fitting rotate in any direction like the original fitting?
Dan |
#4
|
||||
|
||||
|
#5
|
|||
|
|||
It appears that the fitting is rigid when you tighten it up, if so that is entirely different than the ones in the P models
|
#6
|
|||
|
|||
This swivel only has rotational movement in one axis. The OEM swivel not only twists on the long axis but flexes angularly all around the compass. It was mentioned that originally earlier models didn’t have it. Probably added to reduce torsional and flexing stresses on the line (which can lead to line failure). This Phenix swivel may not be an acceptable substitute.
However this point doesn’t solve the original problem of a destroyed swivel. I wonder if Robair can do anything to save the original? My previous search was the OEM are unobtainable at any price. If you have no option but to try to use this swivel, I would watch the line movement during gear swing to see how things go and be prepared for brake failure in use. Last edited by wslade2 : 04-17-23 at 12:07 AM. |
#7
|
|||
|
|||
We did a gear swing with the swivel removed and confirmed there was no interference or stress on the line. The line we have is teflon and the IA would be more comfortable changing the line back to the original material if we were going to eliminate the swivel. I wanted the swivel and so we installed the swivel and confirmed proper operation of the gear with no brake line stress, wear points or interference. The IA is happy and the aircraft has been returned to service.
|
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|