|
|
|||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
03-03-23, 03:29 PM
|
||||
|
||||
|
There are posts here showing how to rebuild it yourself for 75 cents. Shows how it comes apart, etc.
here's one, there are others: http://www.337skymaster.com/messages...ghlight=swivel Use the search function. 
|
|
#3
03-13-23, 06:22 PM
|
|||
|
|||
|
Rebuilt my left one last year, put between two pieces of aluminum in vice, remove internal circlip, remove roll pins, take apart, replace oring, reassemble.
Dan
|
|
#4
04-14-23, 01:49 PM
|
|||
|
|||
|
My brake line swivel has seen better days. Someone previously beat the crap out of it and it is no longer serviceable or repairable. I found a replacement part which is a Phoenix C6-4-6. Cost about $10 plus shipping. Using FAR 43.13 to install. Far better replacement part than the original. Early serial number Skymasters had no brake swivels. I don't know the history on the swivel but I assume it was an improvement done by Service Bulletin in the early days. Then incorporated into later production airplane.
|
|
#6
04-15-23, 08:51 AM
|
|||
|
|||
|
Does that fitting rotate in any direction like the original fitting?
Dan
|
|
#7
04-15-23, 12:46 PM
|
||||
|
||||
|
|
|
#8
04-15-23, 04:22 PM
|
|||
|
|||
|
It appears that the fitting is rigid when you tighten it up, if so that is entirely different than the ones in the P models
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
