New Skymaster Owner

[TomM]

Thanks for the info! My oil and filters will be here this week and I planned on changing the oil this weekend. I will do exactly what you said below to determine the ACTUAL oil levels. Admittedly the dipsticks are really hard to read. I had to clean them up, use a magnifying glass and flash light to read the markings and then scribe lines at the 6 and 8 quart marks to make them easier to read at a glance glance. Thanks again!!

[frank.oconnor19]

I too have found that the oil is best around 7 qts on the dipstick, any more and I just wipe it off the belly. I use 8 qts on an oil change. Not sure what others are doing but I am changing the oil every 30+ hours. Use 50W in colder months and 100W in warmer. No multi viscosity. But that is just me.

I did put in the quick drain plugs, they are STC'd and make getting the oil out of the front engine a lot cleaner.

Frank

[MD83driver]

May I ask who holds the STC for the front quick drain plug, I need to get myself one.

[hharney]

Originally Posted by frank.oconnor19

I did put in the quick drain plugs, they are STC'd and make getting the oil out of the front engine a lot cleaner.

Frank

I did not know that there was a quick drain for the front engine.....was always told the nose wheel is too close

[frank.oconnor19]

this is the one I have, You need to probe attachment as well, there is a 180 degree and a 90 degree version. This is the link to the part. I use the 180 degree version and a section of radiator hose to just have the oil go directly into drain pan. Now if I could only fin a way to keep the case clean when the oil filter comes off.

https://bogertaviation.com/products/...sa4024nm-valve

Frank

[cjordan]

I too have found 7 quarts is max, without just blowing it out. It tends to stabilize around 6.

[hharney]

Originally Posted by frank.oconnor19

this is the one I have, You need to probe attachment as well, there is a 180 degree and a 90 degree version. This is the link to the part. I use the 180 degree version and a section of radiator hose to just have the oil go directly into drain pan. Now if I could only fin a way to keep the case clean when the oil filter comes off.

https://bogertaviation.com/products/...sa4024nm-valve

Frank

That is a pretty expensive set up. $310.00 worth? Not sure I would put this on. It's so easy to just open the nose gear doors and reach up to remove the plug. I guess in thinking about it the quick drain would reduce the chance for over tightening the plug, having to keep crush washers available and wire tying. I may have just talked myself into one of these. Haha

Frank, I am going to have to show you my oil filter trick. It works about 90% on the front and 100% on the rear. Ziplock bag technique

[MD83driver]

Frank, Thanks for the link to the quick drain, Just purchased one for the front engine. They were also having a 20% off sale at the time of my purchase. My reason for getting one is to eliminate the constant removal of the drain plug. Keeping exposure low. Thanks again for the heads up.