|
Register | FAQ | Members List | Calendar | Today's Posts | Search |
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Interconnected elevator trim to flaps
Hello ALL.
FYI. I fixed the problem with the inter-connected flaps and elevator trim. It was a improper rigging. BILLS |
#2
|
||||
|
||||
Interconnected elevator trim to flaps
Hello ALL-Again.
Well I thought I had the flap elevator trim fixed__GUESS NOT. I've gone through the procedure in the maintenance manual going on THREE TIMES! I can get the trim set at the proper degrees of trim UP and DOWN, then when I adjust the interconnect flap-trim I cannot get the proper DOWN TRIM. I only get about 5 degree, it should be 26 degrees, because of the STOP BLOCK #8 on the up cable. This is the block that presses up against the #9 block on the end of the push-pull solid wire cable connected to the Flap bell crank. DOES ANYONE HAVE EXPERIENCE WITH THIS? Thanks for any and ALL help. Regards, BILLS |
#3
|
|||
|
|||
Fixed?
Bill,
Have you solved the issue? I just finished rigging my flaps (C337A) as the previous owner/maintainer had taken a short cut in rigging...anyway... Once I finished rigging the flaps, I went through and checked the elevator trim and interconnect rigging and had to make some slight adjustment. I have everything working - just wanted to see if you did too - or if we put our heads together to solve yours. Jeff |
#4
|
||||
|
||||
Interconnected elevator trim to flaps
JAG.
Yes, thank you, I did fix the flaps/interconnected elevator trim. I had to go through it several times, but I finished with only one dimension (angle of degree) full down elevator trim is off by about 3 degrees. I tried removing the connecting rod and adjust it but it's off 3 degrees the opposite way? It works/flys fine. Thanks again for asking. By the way I was down in the great state of Texas a few months ago for a visit-it was great to be back HOME!! Regards, BILLS |