I have a couple bent stringers under the skin on belly of a T337C. Trying to identify good sheet metal person to help me repair properly. Occurs to me that it might also be beneficial to find a donor airplane that is being parted out to get some of the pieces needed, versus fabricating. From the IPC I am looking at, 337 sn 001 through 1969 (C & T) models all shared the same floor structure. Might even go past that 69 model...but my IPC is dated Jan1,1970, so I don't know.
These would be a few metal pieces, between lower belly skin and floor plates, that normally wouldn't be in demand from a parts plane, so hopefully someone knows a fuselage sitting somewhere that can be a donor to help keep the Bee flying.
Send me email to
networkgunslinger@gmail.com
Hybrid Mode
