Skymaster Forum  

Go Back   Skymaster Forum > Messages
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
Thread Tools Rate Thread Display Modes
  #1  
Unread 06-11-10, 05:21 PM
EDWARD ERNST EDWARD ERNST is offline
Registered User
 
Join Date: Jun 2007
Location: SOUTHOLD, NY
Posts: 2
EDWARD ERNST is an unknown quantity at this point
Boom Bounce

I have experienced what I believe is boom bounce with my 336. Happens around 125 mph. From reading earlier messages, seems like it could be due to excess play in elevator trim, etc.
No flutter in controls, just a rocking feeling in the seat and could see the boom vibrating at that speed. Ok below and above 125. any additional input would be appreciated.
Reply With Quote
  #2  
Unread 06-11-10, 06:03 PM
rick bell rick bell is offline
Registered User
 
Join Date: May 2002
Location: 15 mi south san felipe, mx
Posts: 265
rick bell is an unknown quantity at this point
just a thought, i needed to replace the bolts on the elevator attachment fittings, they had
just a very slight wear. replacing the bolts cured the problems, and it is very easy to
do. didn't take me 1/2 hour. i could not believe that such slight wear could cause that.
Reply With Quote
  #3  
Unread 06-11-10, 11:55 PM
edasmus edasmus is offline
Registered User
 
Join Date: Nov 2006
Location: ARR - Aurora, IL - USA
Posts: 420
edasmus is on a distinguished road
Send a message via AIM to edasmus
I had this happen as well but it was at cruise speeds. Anyway, my IA said he felt the cause was the cable tensions in the elevator were out of tolerance. He made the appropriate adjustments and I have not experienced this again. It has been probably 5 years now.

Ed
Reply With Quote
  #4  
Unread 06-12-10, 08:06 PM
travis's Avatar
travis travis is offline
Registered User
 
Join Date: Sep 2003
Location: KFWS
Posts: 78
travis is an unknown quantity at this point
I found the culprit to be improperly torqued attatchig hardware. The elevator itself is in a low frequency flutter. This could be problematic if left to it's own devices but I found that a change in rear prop RPM would throw the flutter out of phase and interupt the cycle for a while. Anyway two minutes with the end wrenches fixes the problem. One should note that most mechanics fear over tightening the bearings and will not quite finish the job. So a bit more than snug doesthe trick.

_travis
Reply With Quote
  #5  
Unread 10-12-10, 07:30 PM
EDWARD ERNST EDWARD ERNST is offline
Registered User
 
Join Date: Jun 2007
Location: SOUTHOLD, NY
Posts: 2
EDWARD ERNST is an unknown quantity at this point
Boom Bounce

Thanks For The Help, Tightened The Elevator Hinge Bolts Which Took The Play Out And All Is Fine.
Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 09:54 PM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.