Skymaster Forum  

Go Back   Skymaster Forum > Messages
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
Thread Tools Rate Thread Display Modes
  #1  
Unread 12-03-19, 04:49 PM
weebyf15 weebyf15 is offline
Registered User
 
Join Date: Feb 2019
Location: florida
Posts: 31
weebyf15 is on a distinguished road
JPI EMD 760 modification question

I have a 1979 P337/H that originally had the GEM EGT monitors. Years ago they were replaced by a JPI 760. Reading thru the logs/337's I was unable to determine if the original GEM EGT probes were used or even allowed in this modification. However, my question is; I still have the dual mixture adjustment gauge (EGT), in the aircraft. The rear engine needle corresponds to what the JPI reads when running. However the front needle is dead. My question is does the original single EGT probe pull from the JPI probe(s)? Or is it a completely different sensor. Looking at my front and rear engine exhaust stacks I only find one EGT probe for each cylinder and not a second one for the old original equipment EGT probe per engine.
I am just trying to get the front EGT to register on the old gauge like the back does. Ideas?
Reply With Quote
  #2  
Unread 12-03-19, 08:59 PM
hharney's Avatar
hharney hharney is offline
Forum Administrator
 
Join Date: Jul 2002
Location: Michigan (8D4)
Posts: 2,253
hharney is on a distinguished road
The original probes are normally in the junction area where the 3 tubes come together and only on one side of the engine.
__________________
Herb R Harney
1968 337C

Flying the same Skymaster for 47 years
Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 05:16 AM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.