Skymaster Forum  

Go Back   Skymaster Forum > Messages
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Unread 09-24-19, 12:52 AM
wslade2 wslade2 is offline
Registered User
 
Join Date: Feb 2016
Location: none
Posts: 304
wslade2 is on a distinguished road
I have been looking at CiES fuel sensors and Aerospace Logic display since I got into my plane in March. Have spoken with both CiES and Aerospace Logic. Also Possibly newer Electronics International engine monitor with the CiES sensors. Been slowed down with other maintenance items. Of course always dip the tanks.
Reply With Quote
  #2  
Unread 09-25-19, 03:04 PM
patrolpilot's Avatar
patrolpilot patrolpilot is offline
Registered User
 
Join Date: Sep 2019
Location: South Texas
Posts: 312
patrolpilot is on a distinguished road
The more I look at them; I'm thinking the Insight Gem 4 Skymaster over the JPI 760. I like the display a lot better. I'm also thinking of the Strike Finder as well. I have the ForeFlight stuff on the iPad, but I love doubling up on information.

I had a WX-10 in my Piper Pacer commuter, it saved my bacon many night.
Reply With Quote
  #3  
Unread 10-02-19, 11:05 AM
patrolpilot's Avatar
patrolpilot patrolpilot is offline
Registered User
 
Join Date: Sep 2019
Location: South Texas
Posts: 312
patrolpilot is on a distinguished road
I attached the image of measurements I made with my "G" and its long-range tanks. I'm using the J-Hawk J-Air Fuelhawk 11" Universal AvGas Pre-Flight Fuel Dipstick. Also, I sincerely recommend a Fuel Stop - FuelHawk Saver attached to the fuel dipstick. It would be easy to lose the dipstick in any 337 fuel tank.

This was very time consuming work. Each reading was taken with the dipstick resting in the lateral channel that runs down the length of the wing tank. The lowest reading was made with fuel in that channel, directly below the port.

Use the chart at your own risk. Honestly, I will check the accuracy of my recorded data the next time I have the fuel below the filler ports.

The right gauge has stopped working since I bought the airplane. If the problem is in the indicator, I will install the Aerospace Logic FL212 electronic gauge on my aircraft; it is STC'd for the 337.
Attached Images
File Type: jpg Dipstick.jpg (14.9 KB, 2278 views)
File Type: jpg FL212.jpg (3.9 KB, 1940 views)
File Type: jpg FL212_53704.jpg (62.4 KB, 2870 views)
File Type: jpg fuel stop.jpg (9.6 KB, 2413 views)
Reply With Quote
  #4  
Unread 10-02-19, 02:21 PM
wslade2 wslade2 is offline
Registered User
 
Join Date: Feb 2016
Location: none
Posts: 304
wslade2 is on a distinguished road
I'm glad you mentioned the insight Gem 4 engine monitor. I think I am going to head for that. I like the vibration analysis capability. My fuel gauge gone so I will likely be doing the aerospace logic fuel indicator with CiES probes after the holidays at the same time. (In the meantime, I still need to squeeze ADS-B out in before end of December.)
Reply With Quote
  #5  
Unread 10-16-20, 06:05 PM
Learjetter's Avatar
Learjetter Learjetter is offline
Registered User
 
Join Date: Jun 2010
Location: KOKC
Posts: 282
Learjetter is on a distinguished road
One thing about the Aerospace logic fuel gauge: per the STC it can be the only fuel gauge installed. So any later upgrade to glass engine management or glass navigation will mean the aerospace logic unit comes out (or you don’t hook up fuel to the fancy glass stuff).
Reply With Quote
  #6  
Unread 10-19-20, 01:30 AM
wslade2 wslade2 is offline
Registered User
 
Join Date: Feb 2016
Location: none
Posts: 304
wslade2 is on a distinguished road
I plan on replacing my capacitance system with CiES probes and then the aerospace logic indicator. The real cost will probably be the probes and wiring. But probes are compatible with a number of systems.
Reply With Quote
  #7  
Unread 10-21-20, 12:57 PM
Dan M's Avatar
Dan M Dan M is offline
Registered User
 
Join Date: Mar 2016
Location: PA
Posts: 1
Dan M is on a distinguished road
Any recommendations for an electronic fuel gauge?

So has anyone pulled the trigger and actually installed the CiES fuel senders yet? I pulled the left tanks at annual to re-cork the tank straps and now the gauges are shot. I am looking at CiES and any other option out there. I still have the Stewart gauges and would prefer something to work with them for now until I am in a position to get an engine monitor. Anybody know of any other fuel sender options?
Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 02:55 PM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.