Forum: Messages
02-23-10, 03:19 PM
|
Replies: 82
Views: 205,594
|
Forum: Messages
02-21-10, 08:54 PM
|
Replies: 82
Views: 205,594
|
Forum: Messages
04-15-09, 01:07 AM
|
Replies: 22
Views: 28,661
stainless steel or steel?
Does anyone know the history on when the factory went to stainless steel cables and have any of the accidents involved stainless steel cables? I understand later production aircraft were all...
|
Forum: Messages
04-09-09, 01:08 AM
|
Replies: 0
Views: 7,727
flap cables
I understand that their have been two types of cables. Steel and Stainless Steel. The SS cables were the 2nd generation supplied by Cessna. All later production 307s had stainless steel.
Question: Of...
|
Forum: Messages
01-22-09, 12:26 PM
|
Replies: 5
Views: 10,729
|
Forum: Messages
01-21-09, 01:40 PM
|
Replies: 5
Views: 10,729
|
Forum: Messages
01-20-09, 09:46 PM
|
Replies: 5
Views: 10,729
nose gear door
My aircraft has the aft nose gear door. It's occurred to me that I could shed some drag on take-off if it was removed. Any opinions or suggestions on removing this door. Would it require an STC?...
|
Forum: Messages
01-06-09, 11:52 PM
|
Replies: 6
Views: 22,149
|
Forum: Messages
10-11-08, 01:23 AM
|
Replies: 12
Views: 17,742
|
Forum: Messages
08-20-08, 11:24 PM
|
Replies: 6
Views: 16,834
split flaps
In the event of a broken cable and split flaps, does selecting flaps up return the flaps to a symetric position? Ie will both flaps travel to the up position or does the broken cable flap remain in...
|
Forum: Messages
08-10-07, 11:26 PM
|
Replies: 6
Views: 13,311
Ernie, I had the maitenance shop email me...
Ernie, I had the maitenance shop email me pictures that I will forward. Photo quality not very good on the prop damage. This gouge was 3 to 4 inches from the tip. It is at least 1/4 deep and 1/4...
|
Forum: Messages
08-10-07, 08:44 AM
|
Replies: 6
Views: 13,311
|
Forum: Messages
08-08-07, 11:33 PM
|
Replies: 6
Views: 13,311
What the heck?
On the walk a round I found a bullet size hole in the right aileron. It was actually a 3 inch skip pattern with a quarter inch hole in the bottom side of the aleron. Approxamatly one inch from the...
|
Forum: Messages
05-25-07, 12:33 PM
|
Replies: 5
Views: 14,576
|
Forum: Messages
04-27-07, 12:51 PM
|
Replies: 5
Views: 14,576
Paul, thanks for the reply. This warm air is...
Paul, thanks for the reply. This warm air is constant from on the ground to at altitude. Not hot but warm. One source of air identifyed is the outlet next to the co-pilots left knee. Is there a...
|
Forum: Messages
04-25-07, 10:03 PM
|
Replies: 5
Views: 14,576
warm air in cabin
Problem #1 - We are experiencing excessive warm air in the cabin in our P337. The air is coming from a vent below the controll pedistal on the co-pilots side. It may be coming from both sides but...
|
Forum: Messages
01-04-07, 11:54 AM
|
Replies: 2
Views: 10,780
|
Forum: Messages
01-03-07, 10:43 PM
|
Replies: 2
Views: 10,780
back up oxygen
I have a Riley Skyrocket with oxygen generators. Do all P337's use OG's or is this unique to the Riley Skyrocket?
________
How to make vaporizer (http://vaporizers.net)
|
Forum: Messages
03-02-06, 09:36 PM
|
Replies: 30
Views: 46,327
|
Forum: Messages
03-02-06, 12:28 AM
|
Replies: 30
Views: 46,327
Earnie, the simulated inopeative procedure for...
Earnie, the simulated inopeative procedure for some reason is different than what you stated in the Riley Superskyrocket AFM.
It calls for the following:
1) Propeller control - Full High RPM
2)...
|
Forum: Messages
03-02-06, 12:03 AM
|
Replies: 30
Views: 46,327
|
Forum: Messages
02-28-06, 11:35 PM
|
Replies: 30
Views: 46,327
|
Forum: Messages
02-28-06, 11:28 PM
|
Replies: 30
Views: 46,327
|
Forum: Messages
02-28-06, 11:26 PM
|
Replies: 30
Views: 46,327
|
Forum: Messages
02-26-06, 08:39 PM
|
Replies: 30
Views: 46,327
We simulated two engine failures (rear engine)...
We simulated two engine failures (rear engine) after rotation as follows:
1) we used 1500' msl as the mda
2) max gross
3) No flaps
4) Gear down
5) blue line on climb out
6) 10 degrees C
7) 80 knot...
|