Forum: Messages
02-29-20, 11:29 PM
|
Replies: 9
Views: 11,362
Hyd pump
Thanks for the reply’s. Still working the issues.
|
Forum: Messages
02-24-20, 09:47 PM
|
Replies: 9
Views: 11,362
Hyd Pumps
Thanks for the info. Located a hydraulic mule at last and going to check system during annual next week. Still doing the search for pumps or info on overhaul kits and parts .
|
Forum: Messages
02-24-20, 02:56 PM
|
Replies: 9
Views: 11,362
Hyd pumps
I have not used a mule yet. Rear pump suspect. I have been using procedure described in maint manual by using 1 engine on for each pump. We have rebuild all actuators and replaced all hoses. ...
|
Forum: Parts Sources
02-23-20, 09:18 PM
|
Replies: 2
Views: 12,839
Pumps.
Originally installed on aircraft and would not build pressure in system when cycling gear handle. Tried engine run then drill with aircraft on jacks. QAA stated that cases, gears and a shaft were...
|
Forum: Messages
02-22-20, 09:53 AM
|
Replies: 9
Views: 11,362
Hyd pumps.
I spoke with Power pacs + and quality. Was going to call Tulsa ,Cox and two shops in Atlanta that I know of. There is a shortage of pump parts or kits. And now rebuildable cores. According those...
|
Forum: Messages
02-22-20, 12:53 AM
|
Replies: 9
Views: 11,362
Hyd Pumps
Both of my pumps were returned from qaa as unserviceable. No luck on locating replacements within reason. Any serviceable cores available ? Alternate Part numbers ? Many accessory overhaul...
|
Forum: Parts Sources
02-22-20, 12:48 AM
|
Replies: 2
Views: 12,839
WTB hydraulic pumps
Both of my pumps were returned from qaa as unserviceable. No luck on locating replacements within reason. Any serviceable cores available ? Alternate Part numbers ? Many accessory overhaul...
|
Forum: Messages
06-23-18, 04:59 PM
|
Replies: 1
Views: 9,702
Service manual
Any operators or mechanics have revisions for nose landing gear and actuator for service and parts manual. My old copy has an issue with the breakdown in the PM for the nose landing gear actuator...
|
Forum: Parts For Sale
12-30-16, 09:54 PM
|
Replies: 3
Views: 15,090
|
Forum: Parts For Sale
12-29-16, 09:04 PM
|
Replies: 3
Views: 15,090
Tachometer
I need a working or repairable tach. Pn C668010-0101. I've sent mine out for overhaul and the shop is having difficulties. Pm or email gmpoland@graceba.net.
|
Forum: Messages
12-20-16, 09:39 PM
|
Replies: 3
Views: 11,308
Nose gear uplock
Upon several assembly and disassembly attempts with the same result. Gear would retract completely then not extend as the nose gear would not unlock. Had to manually reach into compartment with pry...
|
Forum: Messages
11-21-16, 08:20 PM
|
Replies: 3
Views: 11,308
Nose gear uplock.
After several disassembly and reassembly events using 5606 as well as petrolatum. We discovered a very slight difference in thickness of the oring pn 6277B11. Opened a different package and tried...
|
Forum: Messages
11-16-16, 11:50 AM
|
Replies: 3
Views: 11,308
Nose gear up lock assembly
Upon reassembly of a nose gear up lock actuator on a 65 SN 0127 with new o rings it was exceptionally difficult to move the shaft. O ring from Parts manual Fig 122A item 7 Pn AN 6227B11. seems to be...
|
Forum: Messages
08-18-14, 01:14 AM
|
Replies: 7
Views: 14,192
Oil vent
I ran mine to nearly same location to accommodate an oil/air separator.
|
Forum: Messages
06-11-13, 10:26 PM
|
Replies: 2
Views: 9,768
Airwolf Air Oil Sep on Rear Engine
After much discussion with Airwolf. Wound up mounting Separator on Oil Fill tube with supplied Adel clamps and cutting/reconfiguring engine vapor line that runs from front to rear of engine then out...
|
Forum: Messages
06-05-13, 10:05 AM
|
Replies: 2
Views: 9,768
|
Forum: Messages
04-23-13, 06:15 AM
|
Replies: 10
Views: 15,930
Rear Cowl Flap Motor
No. Service and parts manual were vague. I got some help from a Service Rep by the name of Bill Glen. I will post it anyway so you can check and see if it clears up questions. MIne had resitor...
|
Forum: Messages
04-21-13, 09:21 PM
|
Replies: 10
Views: 15,930
Cowl Flap resistor.
I ran into several problems with my rear cowl flap motor with this resistor being installed on the wrong wire. I have a Cessna wire diagram that shows installation if you still need info. ...
|
Forum: Parts For Sale
04-21-13, 09:17 PM
|
Replies: 20
Views: 58,987
Parts
Any chance you still have a rear spinner? GMPoland@graeba.net
|
Forum: Messages
03-02-13, 03:02 PM
|
Replies: 0
Views: 7,895
FAA Form 337. Mitchell instruments mod.
Have any of our fellow skymaster owners completed the conversion from the factory guages to the Mitchell instrument cluster for engine instruments as depicted in the link on this website?
If so, May...
|
Forum: Parts For Sale
10-24-12, 04:58 PM
|
Replies: 2
Views: 14,337
ei. EE1P. Egt
If you still have the egt gauge I will take it. GMPoland@graceba.net. 334-618-8608
|
Forum: Messages
05-19-11, 10:20 PM
|
Replies: 3
Views: 10,963
Wires and breakers
I just spent the after noon visiting with a very gracious Don Niesner. He was helpful with all my questions and very patient to let me look at the selection of 02and 337 parts he has on hand. My...
|
Forum: Messages
05-17-11, 08:17 PM
|
Replies: 3
Views: 10,963
337 SN0127 Restoration
Need some help identifying a contactor on my fire wall. its not suppling power to any system and not in parts or any other documents I can find. Contactor is located on the center to Right side on...
|
Forum: Parts For Sale
02-08-07, 11:09 AM
|
Replies: 29
Views: 53,404
Skymaster Lemonade
If you have the complete parking brake assy (handle to cylinders) I would be interested. Also wingtips if usable. e-mail at GMPoland@hotmail.com.
|
Forum: Messages
02-08-07, 11:02 AM
|
Replies: 4
Views: 11,635
Skymasters At Work
While Deployed to Iraq I found a familar aircraft at one of our airfields.
|