Skymaster Forum  

Go Back   Skymaster Forum > Search Forums
Register FAQ Members List Calendar Today's Posts

Showing results 1 to 25 of 150
Search took 0.01 seconds.
Search: Posts Made By: JeffAxel
Forum: Messages 05-10-23, 04:38 PM
Replies: 8
Views: 29,916
Posted By JeffAxel
Check with an insurance agent, especially if you...

Check with an insurance agent, especially if you are getting a P Skymaster. You might find insurance to be very expensive or unobtainable with only 45 hours. A thorough pre buy is a must, lots of...
Forum: Messages 11-11-22, 02:48 PM
Replies: 7
Views: 107,967
Posted By JeffAxel
doesn't make any difference, if you have an...

doesn't make any difference, if you have an engine monitor, you can do a GAMI lean test to see how wide your fuel flow spread is between first to peak and last to peak. If you get a lot of rough...
Forum: Messages 11-11-22, 01:20 PM
Replies: 7
Views: 107,967
Posted By JeffAxel
I ran my P337 LOP for the three years I owned it,...

I ran my P337 LOP for the three years I owned it, would true out at 180-185KTAS in the high teens on 23-24gph. Ran cool CHTs in cruise, clean spark plugs.
Forum: Messages 09-05-22, 07:29 PM
Replies: 18
Views: 54,885
Posted By JeffAxel
I used a battery powered Power Tow when I had my...

I used a battery powered Power Tow when I had my T337G. It did okay but it was definitely working hard to push the plane uphill when full of fuel. Very easy to maneuver the plane though. One of the...
Forum: Messages 04-08-22, 04:24 PM
Replies: 17
Views: 29,410
Posted By JeffAxel
Max pressure differential on the P337 is 3.35psi....

Max pressure differential on the P337 is 3.35psi. Should hold a 10000ft cabin at FL200 with either engine running. Check the flap cables, they make a sharp bend and the damage is hard to see, Cessna...
Forum: Flight Instruction and Recurrent Training 01-27-22, 08:16 PM
Replies: 2
Views: 26,126
Posted By JeffAxel
You might give Larry Schmidlin a...

You might give Larry Schmidlin a shout:

larryschmidlin@cs.com
503 939 8264

Did my P337 training with him a long while back, he might still be around....
Forum: Mechanics and Service Providers 10-27-21, 07:21 PM
Replies: 3
Views: 44,537
Posted By JeffAxel
Aero Air is a good shop, but they mostly work on...

Aero Air is a good shop, but they mostly work on turbine equipment. Northwest Aircraft Maintenance, also at HIO took care of my P337G for the three years that I had it. Rian and Dirk are good honest...
Forum: Messages 08-27-21, 11:41 PM
Replies: 4
Views: 16,562
Posted By JeffAxel
I think Air Mod in Ohio has them.

I think Air Mod in Ohio has them.
Forum: Messages 08-02-21, 01:03 PM
Replies: 24
Views: 50,916
Posted By JeffAxel
I think your idea of offering a discount for...

I think your idea of offering a discount for annual training is a good one. When FlightSafety had a 210 simulator, I went there annually to take their training. Not required, but my plane was a...
Forum: Messages 08-02-21, 12:34 AM
Replies: 24
Views: 50,916
Posted By JeffAxel
David, the 337 should be one of the safest ...

David, the 337 should be one of the safest planes out there, but the experience with it has been different. Pilots don't take it seriously enough. One thing I have learned is the thing that is the...
Forum: Messages 07-31-21, 07:45 PM
Replies: 24
Views: 50,916
Posted By JeffAxel
"The MU2's were intriguing also. But the accident...

"The MU2's were intriguing also.
But the accident reports always seemed to read the same:
"The pilot had 5,000 hours in make and model"
"The wreckage was spread over a file mile radius"

Too...
Forum: Messages 07-12-21, 06:05 PM
Replies: 24
Views: 50,916
Posted By JeffAxel
FWIW, I am a 62yr old physician! The MU2 is my...

FWIW, I am a 62yr old physician! The MU2 is my first turbine, and yes it was a big learning curve. I figured if I was going to get an MU2, better do it before my brain was too fossilized to learn...
Forum: Messages 07-12-21, 05:35 PM
Replies: 24
Views: 50,916
Posted By JeffAxel
I don't have a Marquis, I have a 1972 F model,...

I don't have a Marquis, I have a 1972 F model, the "low performance" MU2, only 260KTAS vs 300KTS. Burns less fuel though. Training was $6K initial and will be $3K annually. Insurance was $9K for...
Forum: Messages 07-12-21, 12:31 PM
Replies: 24
Views: 50,916
Posted By JeffAxel
Awful lot of information in the MU2 POH about...

Awful lot of information in the MU2 POH about flying in icing. Engine inlet heat on (bleed air source), ignitors on continuous, prop heat on, boots on. Pitot heat should be turned on when taking the...
Forum: Messages 07-12-21, 12:24 AM
Replies: 24
Views: 50,916
Posted By JeffAxel
I agree with all that is said about the 337 and...

I agree with all that is said about the 337 and how easy it is, that why I bought one. Not sure I agree with the MU2 stuff. It is different and has to flown differently, but once you understand those...
Forum: Messages 07-11-21, 08:02 PM
Replies: 24
Views: 50,916
Posted By JeffAxel
Tim, polite suggestion, do what I did, sell the...

Tim,
polite suggestion, do what I did, sell the Skymaster and find an F model MU2. Way better plane, but more expensive to operate, not that much more, but more. You do get a lot for the money...
Forum: Messages 01-07-21, 02:11 PM
Replies: 54
Views: 126,317
Posted By JeffAxel
their website is still active and the...

their website is still active and the installation manuals can be downloaded from there.
Forum: Messages 10-07-20, 11:50 PM
Replies: 16
Views: 25,595
Posted By JeffAxel
My hangar measures 230" from the wall of the T to...

My hangar measures 230" from the wall of the T to the door, my P337 fit with loads of room to spare, didn't even have to disconnect my Powertow tug to close the door. Where do you live? If it is warm...
Forum: Messages 08-11-20, 12:01 AM
Replies: 31
Views: 77,192
Posted By JeffAxel
I had GAMIs on my P337 and the engines ran fine...

I had GAMIs on my P337 and the engines ran fine with them. Ran them at 65% power, 23-24gph total in cruise which got me a TAS of 185 in the high teens with cool temperatures even in the summer with...
Forum: Messages 08-10-20, 07:21 PM
Replies: 31
Views: 77,192
Posted By JeffAxel
Nice, saw the advertisement. Do I remember that...

Nice, saw the advertisement. Do I remember that both engines were very high time? I was tempted to call our local engine shop (Premier Aircraft, Troutdale OR) to see what overhauls would cost for...
Forum: Messages 08-10-20, 12:19 AM
Replies: 31
Views: 77,192
Posted By JeffAxel
pictures, or it didn't happen! As to getting to...

pictures, or it didn't happen! As to getting to the rear alternator, take the interior coverings off the rear wall of the cabin and there is an inspection plate you can remove to get access to the...
Forum: Aircraft For Sale 07-01-20, 11:40 PM
Replies: 29
Views: 63,964
Posted By JeffAxel
N27JA is not pressurized if the picture I saw of...

N27JA is not pressurized if the picture I saw of it is correct.
Forum: Aircraft For Sale 07-01-20, 12:30 AM
Replies: 29
Views: 63,964
Posted By JeffAxel
What JimC said. The P337 needs to be at 120KIAS...

What JimC said. The P337 needs to be at 120KIAS or more to stay cool enough in climb most of the year, 500fpm is realistic with acceptable temps, although there are some cooling mods that can help I...
Forum: Aircraft For Sale 06-30-20, 01:03 AM
Replies: 29
Views: 63,964
Posted By JeffAxel
The P337 only goes up to FL200. It burns 24gph...

The P337 only goes up to FL200. It burns 24gph LOP at 65% power there and will do 185KTAS at that power setting. It isn't a bad aircraft by any means, actually very easy to fly and very stable in IFR...
Forum: Aircraft For Sale 06-27-20, 01:17 AM
Replies: 29
Views: 63,964
Posted By JeffAxel
The P337 is a 5 hour airplane with an hours...

The P337 is a 5 hour airplane with an hours reserve flown at 65% power, you won't do 1400nm unless you have a really strong tailwind. How much you need to carry? A 148 gallon P337 won't hold over...
Showing results 1 to 25 of 150

 
Forum Jump

All times are GMT -4. The time now is 06:45 PM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.