Birdstrike. Need Part # for 337C

[rhurt]

Dad killed a red-tailed hawk with his starboard landing light lens cover. Never even knew it until he started to put it in the hangar. The problem is neither of us have a parts manual handy(mine's 70 miles away in Nashville and his is in Naples). Does anyone know the part number for the replacement lens?

[Ernie Martin]

I think you want a 1422550-12 if your aircraft S/N is up to 337-0379 or 1422550-20, which is the more current number. But it's for the entire lamp assembly, and there's no P/N for just the lens. See figure below. Shouldn't be hard to find from yards that disassemble aircraft. Try Don Nieser first at 405-503-4686 or 405-722-4079.

Ernie

[K337A]

Try here. Cheapest I have found if Don doesn't have it.
Good quality. Comes PMAed. Installing it is interesting if the aircraft is STOL equipped.

http://www.glapinc.com/estore/index.php?cPath=639_66

[rhurt]

Originally Posted by K337A

Try here. Cheapest I have found if Don doesn't have it.
Good quality. Comes PMAed. Installing it is interesting if the aircraft is STOL equipped.

http://www.glapinc.com/estore/index.php?cPath=639_66

Thanks. We'll check them out too. It's not STOL equipped, so we don't have that hurdle to jump.

At least dad didn't have to land in the Hudson.

[rhurt]

Dad got the part from Great Lakes Aero Plastics. $35 plus shipping and handling. He received the part Thursday morning, got all the screws out of the frame O.K. and the new lens fit perfectly. Done.

He killed a hawk with his Skymaster and it cost him less than $50 for repairs. It probably would have cost more if I had killed one with my car.

Thanks Ernie and K337A for your help.

Randy Hurt (N6297F)
Ron Hurt (N2577S)

[edasmus]

That's great! This flying hobby sure is cheap!!!! ;o)

[Ernie Martin]

The real jewel here is K337A finding just the lens at Great Lakes Aero Plastics. This "find" was important enough that I added Great Lakes to the source list on the Parts Purchasing page of my "backup" Skymaster website at www.SkymasterUS.com

Ernie

[rhurt]

Thanks Ernie. We'll call Don.

Randy Hurt