|
|
#1
|
|||
|
|||
|
Gear swing height
Hi im in the process of fabricating jacks to do gear swing but have not been able to find what hight i need to elevate to clear ground
I se that one manufacturer have a travel of 25 inches I have some Hydraulik pistons with @ 18 inch travel i was hoping to use Anyone have a minimum lift number Best wishes from Denmark 
|
|
#2
06-05-22, 11:20 AM
|
|||
|
|||
|
I have a set of Alpha 868HLW the rams travel 25 inches according to their website. The website also shows 868 model number for 337, however I believe it’s Ram is about 18 inches.
Dan N67S
|
|
#3
06-05-22, 12:37 PM
|
|||
|
|||
|
In the Service Manual for my G model, it calls for thirty-three (33) inches of clearance between the belly and the hangar floor for a gear swing.
Rick
__________________
N337K-FT337GP KLOU
|
|
#4
06-06-22, 05:32 AM
|
|||
|
|||
|
Perfect thanks
Well thats perfect
Thanks gentlemen
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
