Skymaster Forum  

Go Back   Skymaster Forum > Messages
Register FAQ Members List Calendar Today's Posts

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Unread 08-23-10, 05:49 AM
hharney's Avatar
hharney hharney is offline
Forum Administrator
 
Join Date: Jul 2002
Location: Michigan (8D4)
Posts: 2,255
hharney is on a distinguished road
Paul
Two items to consider, the fuel flow divider and the check valves. I am going through a similar scenario also but instead of the rich, flooded symptoms on start up I have fuel draining out of the cylinders through the small drain tubes from the engine cylinders. I have explored both items above. Changed the check valves, from the return fuel lines back to the tank, in the wing root and this did not solve the problem. You can check these pretty easy and pull them apart. The fuel divider on the top of the engine that distributes the fuel to each injector has a spring that holds a diaphragm closed when there is not pressure in the system. This spring or diaphragm can get weak / tear and will allow fuel to trickle into the cylinders while the engine is off. Are you seeing any oil or fuel dripping from the drain tubes on the rear of the engine cowl?

Here is a test you can try, use the aircraft and when you shut down the engine turn the fuel selector to OFF. The next time you go out see if that changed anything.

BTW, I had the flow divider rebuilt and it still did not quit. This is after I changed the spring, diaphragm and the stem. I had to pull the fuel divider back off and send it back to the rebuild shop and they tested it on the bench fixed it, not sure yet what, and it's hopefully solved the issue. I don't know yet because I am still out of the country but from what my mechanic says.......and Larry is suppose to fly it, it is not leaking.

Anyone else ever have this issue of fuel leaking from the cylinders? Looks like oil but it's fuel.
__________________
Herb R Harney
1968 337C

Flying the same Skymaster for 47 years
Reply With Quote
  #2  
Unread 08-24-10, 08:25 PM
Paul462 Paul462 is offline
Registered User
 
Join Date: May 2003
Location: Florida
Posts: 137
Paul462 is an unknown quantity at this point
Thanks for the input, Herb! Yes, the rear engine drips fuel when the airplane sits. We overhauled the fuel divider three times to no avail, and replaced the primer O-rings (also no avail). Nowadays I turn the rear engine fuel selector off, which minimizes the fuel drippage.
__________________
Paul
T337C
Reply With Quote
  #3  
Unread 08-25-10, 04:08 AM
hharney's Avatar
hharney hharney is offline
Forum Administrator
 
Join Date: Jul 2002
Location: Michigan (8D4)
Posts: 2,255
hharney is on a distinguished road
Sounds just like my issue with the front engine. We have to come up with something to solve this issue. The company in Texas (don't remember their name) says that the fuel pump could be the issue. The fuel is leaking past the diaphragm or valve or something but it's like $800 to rebuild the fuel pump. Have you looked at this?
__________________
Herb R Harney
1968 337C

Flying the same Skymaster for 47 years
Reply With Quote
  #4  
Unread 09-07-10, 10:43 PM
Paul462 Paul462 is offline
Registered User
 
Join Date: May 2003
Location: Florida
Posts: 137
Paul462 is an unknown quantity at this point
The rear engine drip we're getting can only come through the fuel divider or the primer. The fuel divider is upstream from the fuel pump(s), so if the fuel divider were doing its job, it would cut off the fuel flow, and stop the drip.
__________________
Paul
T337C
Reply With Quote
  #5  
Unread 09-09-10, 11:14 PM
rmorris rmorris is offline
Registered User
 
Join Date: Nov 2007
Location: NN
Posts: 267
rmorris is an unknown quantity at this point
throttle body

Remember that there is another portion of the fuel system that you might consider....I overlooked it orginally when getting my system overhauled on the front engine. I was having issues with the high/low fuel flow settings, and they tried a bunch. I then overhauled the spider, fuel pump, cleaned injectors, adjusted fuel flow to book specs....then finally someone said - hey, what about the throttle body. Tried one from another Skymaster, and problem went away. I sent mine out for overhaul, and all has been good on that issue since (over a year now).

On a related note -- I mentioned all the issues to another a&p about a month later, without telling him the fix. he said, just replace the throttle body with an overhauled one. Says he keeps an extra one lying around for troubleshooting. Go figure, never know which mechanic will have which little jewel of information. Guess that's why we all try to share info on this website, eh?
________
HOW TO MAKE A VAPORIZER

Last edited by rmorris : 03-12-11 at 12:08 PM.
Reply With Quote
  #6  
Unread 10-06-10, 01:13 PM
hharney's Avatar
hharney hharney is offline
Forum Administrator
 
Join Date: Jul 2002
Location: Michigan (8D4)
Posts: 2,255
hharney is on a distinguished road
Update on fuel draining

I have a new exchange fuel pump and throttle body on the front engine. In earlier post I had the fuel divider overhauled and still had the draining issue but worse than before it was overhauled. Sent it back to the repair station and they bench tested it and said all was fine. So that's when I sent everything, pump, throttle body and divider valve (injection lines and injectors) to ACI in Texas. They said that the throttle body was old and obsolete, had the wrong adjuster set screw in the servo, fuel pump was also obsolete (all these were original) and they charged me a bunch of money for new exchange units off their shelf. Well we got it all back together and low and behold the drains still leak. Post flight or engine operation, fuel will leak out of the cylinder drains. ACI did not mess with the divider valve because it was under warranty and they said their bench test was good.

The divider valve will hold 4 PSI under operation and 2 PSI while static. We put a gauge on the line from the servo and it reads just barley 1 PSI. We also left the line off the servo overnight with the fuel selector on to see if the fuel could be coming from somewhere else but there was not fuel leaking in that procedure. So after spending well into $2500 it still leaks. Yes I have a new pump, throttle body, divider valve, etc. but this whole issue started with the fuel leak that is still there. Next step is to send the divider back to the repair station and bench test again. It has to be passing through the divider.

On a second note, we did some fuel pressure adjustments too. It was suggested by the Texas shop to just verify their factory settings. The fuel pressures were low so we did some ground testing and adjustment. The one thing that is concerning is that you can't get full RPM on the ground. There is an correction table that provides multipliers for compensating but it only indicates to -120 RPMS max and I could only get 2550 RPMS. The procedure calls out 2800. Well that's -250 RPMS. We did some calculating and came up with the multiplier and set it. When we flew the aircraft it achieves the 2800 on take off but the fuel flow was pegged on the engine we adjusted. We turned it back down a little and I need to fly it again to see where it's at. Next month we are installing the JPI 760 with fuel flow that I purchased at Oshkosh this year. I really don't trust the fuel flow gauge in the panel for accuracy.

Anyone else ever have fun with fuel pressure adjustments?

And to end it all, I can't get my G5 power mac to start up, really weird thing going on there too.

Stay tuned.
__________________
Herb R Harney
1968 337C

Flying the same Skymaster for 47 years
Reply With Quote
  #7  
Unread 04-01-11, 12:58 PM
edasmus edasmus is offline
Registered User
 
Join Date: Nov 2006
Location: ARR - Aurora, IL - USA
Posts: 420
edasmus is on a distinguished road
Send a message via AIM to edasmus
Herb:

After a flight last weekend, I have noticed a very very slight drip of fuel coming from the cylinder drain tube from my rear engine. I have never noticed this before. I sat and watched the tube for about 10 minutes and witnessed maybe one drip per 90 to 120 seconds on average. I was reading this thread and was wondering if you ever resolved all this with a high confidence level as to the cause?

Thanks, Ed
Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 05:07 PM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.