Prop Governor and Synchro Slave

[edasmus]

My shop removed all prop sync hardware in my plane several years ago after I installed new prop governors. Have not missed the system for one single second.

Ed

[hharney]

Ed
What's your serial number? Do you have any photos of the rear gov slave?


Does anyone have the McCauley service manual on the governor?

[edasmus]

Herb,

My serial number is 33701473. When I purchased the airplane in 2002, I spent a few bucks trying to get the prop sync to work properly. Didn't have much luck. Then when I replaced the prop governors a few years ago, (we have had that conversation in previous posts) there was additional costs getting governors with the necessary "stuff" to have the prop sync system function. Well, I had not been using the sync system anyhow and never felt it was worth one penny anyway so I saved a few bucks and purchased prop governors that did not have the "bells and whistles" for the prop sync system.

I am not sure exactly what you want me to photo. I have my old governors and could take some photos of them if that might help you. As mentioned, I do not think my new governors would help you at all.

Ed

[hharney]

The first post of this thread included an attachment from the service manual that depicted the governors, with and without synch. Did yours look like these on the figure? It appears that according to the SM the governor that we have is not suppose to be on this aircraft. Also it has a strange configured max RPM stop and screw. Doesn't look right as the photo attached to the same message is also there. Just trying to understand these units. Where your originals McCauley Governors?

[edasmus]

Herb,

I will dig out my old governors tomorrow night or early Saturday morning and see what can be learned. I will take some photos and attach.

Ed

[edasmus]

Herb,

I have my old governors. They look nothing like your photos. I will post photos tomorrow night when I get my camera.

As far as I can tell these governors came with my airplane in 1973 as McCauley model number CFS310D1A/T1. These units appear identical and have identical model numbers. They were overhauled in 1988 by Maxwell Aircraft Service, INC at the Crystal Airport in Minneapolis, MN and both governors were converted at that time to model number CFS310D1B/T1. I do not know why or what the difference is between the two models.

About 4 or so years ago I tried to have them overhauled again and two shops said NO. The shops were Aircraft Propeller, INC in Wheeling, IL at the KPWK airport and Aircraft Systems, INC in Rockford, IL at the KRFD airport. I did not discover the paperwork on these governors that came with the overhaul in 1988 until after purchasing two brand new governors. I do not know if this Maxwell Aircraft Service, INC is still in business but it might be fun to try and see what they would say about these old governors. I can say they were working normally when they were removed about 4 years ago and have been sitting in my closet ever since.

I will have photos tomorrow night at about this time.

Good Luck,

Ed

[edasmus]

Good news is I have photos. Bad news is they are too large to post. I emailed you two of them. There are more if you would like them.

Ed