![]() |
|
Register | FAQ | Members List | Calendar | Today's Posts | Search |
|
Thread Tools | Rate Thread | Display Modes |
#9
|
||||
|
||||
Hi Herb
Any learnings on fitting the new gaskets, I will be replacing all mine before I close the wings. I have all the new gaskets and those little rubber washers ready to go. Mind you it will be a couple of months before I get to it. I found two sender units leakering when I pulled the tank covers off, also I have read a few comments on leaking fuel tanks over the last couple of days. Of my 6 tanks and the two little sub tanks I will carry out in total 7 welds on very small splits / pin holes. Each repair is welded then it has another circular disc welded over that, according to the approved engineer who is conducting the repairs, this is a very common issue and he does them all to often. Anyway I am aiming for a leak free fuel storage and supply ![]() Regards Dave |