Nosegear Warning Plate

[MD83driver]

Would this be the one your are thinking of. Off of my P337H. Before restoring it.

[Rick Erwin]

OhioSkymaster, if you're looking for the placard about the hydraulic pump circuit breaker, I had some made for my plane, along with a slew of other placards also.

The guy that made them would still have the template and can make more of them if that's what you're after. He's available at dean@pipts.com.

MD83Driver, I don't recall seeing that placard. I remember reading about it though. Where does it go?

Rick

[MD83driver]

Rick, The placard is shown in fig.2 Item 37. It is not shown in the parts catalog of the nose strut. Here are pictures of the installed placard as it was on my plane. These are the only pictures I have. Ray

[Rick Erwin]

Thanks Ray. Figure 2 is where I must have seen the placard.

I'll have to check whether it's there tomorrow. I'm thinking it's not...

Rick

[Rick Erwin]

It's there! I'd never noticed it. Something else to restore.

Thanks again, Ray

[wslade2]

I always wondered what that plate was there for!

[Rick Erwin]

wslade2, you're ahead of me as I had never noticed it.

Dean is making me a placard for it, red-faced laminate, laser cut white letters. I will spray it with a couple coats of clear to help with abrasion.

I'll first have to remove the placard holder to clean up the ferrous metal and prime it before I attach the new placard. He's using a type of laminate that has a strong adhesive backing, so it should stick well. I'll be the guinea pig for the first run at the thing.

If anybody else wants one, let Dean know at dean@pipts.com as it'd be easy to have the machine make several rather than one. He's asking $20 bucks.

He's done all kinds of panels, 3D maker stuff, placards, decals for me. Excellent work, reasonable prices.

Rick