Universal Jacking Pads

[skymstr02]

The Cessna part number is 10004-98, but there are aftermarket units out there. Please check with Trade-A-Plane, or places that specialize in the specific tools, as Cessna probably doesn't carry that any longer

[rick bell]

you can use two 2x4's with two c-clamps and a hyd. floor jack. i have done this several time to replace a bad tire in remote areas. works ok, just place the wood on each side of the flat strut lock down the c-clamps and raise up the floor jack on the bottom 2x4, chock the other wheels as it tends to roll a little,

[Kim Geyer]

I want cessna parts .com shows them in stock @ $110.00 ea.
Kim

[Paul462]

Thanks much for the info, guys!

Apparently Bogert Aviation (WA State (800)627-8088) has their "Flat To The Point Jack Pad" P/N 80JSPP which fits C337s for $79 - I ordered one today. I hope it fits!

Rumor has it that Spruce also carries universal jack pads.

[Paul462]

Amigos,

The $79 Bogert Aviation (WA State (800)627-8088) "Flat To The Point Jack Pad" P/N 80JSPP has arrived - it's bright yellow and adjustable, and looks like it will work fine! It comes with a jack tip which you put over the top of the jack, which mates with the pad itself via a ball-in-socket arrangement.

Looks good - I'll advise if we have any problems with it.

[skymstr02]

Paul,
Thanks for the update.

Dave

[WebMaster]

Paul,

If you get a chance to take a picture of this, installed or in operation, we would all be gratefull.

Thank You,
Larry