gear Warning Horn

frank.oconnor19 · #1 01-19-20, 05:44 PM

I did my tests last week and all is well. 20.00 on replacement wait h and a few wire connectors. Small piece of advice for anyone trying this....make sure you put a clean rag under the assembly. The lock washers and nuts are small and easy to drop. Much better if you have a limited area to search.

rmorris · #2 01-20-20, 01:18 PM

Quote:

Originally Posted by frank.oconnor19

I did my tests last week and all is well. 20.00 on replacement wait h and a few wire connectors. Small piece of advice for anyone trying this....make sure you put a clean day under the assembly. The lock washers Me nuts are small and easy to drop. Much better if you have a limited area to search.

You pulled the cessna part number out of IPC, or found a better source for replacement microswitch?

frank.oconnor19 · #3 01-20-20, 01:50 PM

I have the Cessna parts manual. So got the part number there.. it has been superseded so I used the newer part number.

cessnadriver · #4 01-20-20, 08:26 PM

Frank.
Just asking-but are you sure it's the gear horn?? I had a horn, thought it was the gear but found out it was the stall portion of the horn going off. I had pressure washed that wing after stripping! Water in the stall switch. FYI.

BILLS